A grandfather clock case is the tall wooden case of a longcase clock, the type popularly known as a grandfather clock. It consists of a hood, which encloses the dial and movement and either slides forward or opens with a glazed door; a long trunk with a door, which houses the weights and pendulum; and a base or plinth on which the whole stands.
Longcase clocks were made in England from around 1660, following the introduction of the pendulum. Early London cases were ebonised or veneered in walnut, with marquetry and parquetry fashionable towards the end of the seventeenth century and lacquer in the early eighteenth. Mahogany became dominant in the later Georgian period, while provincial makers used oak, often with mahogany crossbanding, and pine for simpler cases that were painted or grained. Movements and cases were usually made by separate craftsmen, so collectors check that the movement truly belongs to its case: mismatched marriages are common, betrayed by filled screw holes, an altered seatboard or a dial that does not fit the hood aperture. Original feet, finials and hood frets, unrestored veneers and good colour all add value, whereas cases cut down to fit low ceilings are less desirable.
































